diff options
Diffstat (limited to 'recipes-connectivity/lora/lora-gateway/library.cfg')
| -rw-r--r-- | recipes-connectivity/lora/lora-gateway/library.cfg | 73 |
1 files changed, 0 insertions, 73 deletions
diff --git a/recipes-connectivity/lora/lora-gateway/library.cfg b/recipes-connectivity/lora/lora-gateway/library.cfg deleted file mode 100644 index 01b066d..0000000 --- a/recipes-connectivity/lora/lora-gateway/library.cfg +++ /dev/null @@ -1,73 +0,0 @@ -# That file will be included in the Makefile files that have hardware dependencies - -### SPI interface to the concentrator ### -# Accepted values: -# native Linux native SPI driver (/dev/spidev32766.0) -# ftdi FTDI SPI-over-USB bridge using libmpsse/libftdi/libusb - -CFG_SPI= ftdi -CFG_SPI_DEV = "/dev/spidev32766.2" - -### Concentrator chip ### -# Accepted values: -# sx1301 Semtech SX1301 production chip -# fpga1301 FPGA containing the SX1301 IP - -CFG_CHIP= sx1301 - -### Radio chip(s) ### -# Accepted values: -# sx1257 Dual SX1257 transceivers, covering 860-1000 MHz -# sx1255 Dual SX1255 transceivers, covering 400-510 MHz - -CFG_RADIO= sx1257 - -### RF band configuration ### -# Used to configured frequency restrictions (eg. if a SAW filter is installed) -# Accepted values: -# full Full range supported by the radio(s) -# eu868 ETSI 868 (866) MHz band -# us915 FCC 915 MHz band -# cn470 China 470 MHz band -# eu433 ETSI 433 MHz band -# cn780 China 780 MHz band - -CFG_BAND= full - -### Board misc parameters & calibration ### -# Used to configure misc board options. -# RX RSSI indication and TX power are highly dependant on radio, band, filter -# and RF front-ends, and must be calibrated for each new board design. -# Available calibration parameters: -# dev_nano_868 FPGA-based nano-concentrator, with 868 MHz SAW filter -# ref_1301_868 SX1301 reference board with SX1257 radios, 868 MHz filters -# ref_1301_433 SX1301 reference board with SX1255 radios, 433 MHz filters -# kerlink_868 Kerlink LoRa 868MHz gateway -# kerlink_433 Kerlink LoRa 433MHz gateway -# cisco_433 Cisco LoRa 433MHz gateway -# cisco_470 Cisco LoRa 470MHz gateway -# cisco_780 Cisco LoRa 780MHz gateway -# Keep empty for no calibration parameters (neutral values will be used). - -# MTAC-LORA 900MHz -CFG_BRD= mtaclora - -### Network Type ### -# Accepted values: -# private Default -# lora_mac Only compliant with devices running LoRa MAC - -CFG_NET= private - -### Debug options ### -# Set the DEBUG_* to 1 to activate debug mode in individual modules. -# Warning: that makes the module *very verbose*, do not use for production - -DEBUG_AUX= 0 -DEBUG_SPI= 0 -DEBUG_REG= 0 -# jjg - turning this on is useful to get HAL-related error messages that -# don't print out otherwise. It doesn't seem to add that much printing -# under normal operation. -DEBUG_HAL= 1 -DEBUG_GPS= 0 |