blob: d08843a2c1f55c9145ee28992b40bda09f8f67ac (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
|
# This change sets the bootdelay to 2 seconds. On old devices
# the bootdelay may be in the environment variable partitions.
# When updating a system, u-boot setenv command must be used
# to set the bootdelay to 2 in the environment. A bootdelay
# of zero will make it nearly impossible to enter U-Boot,
# and zero is the old default, and may be in the environment.
# For MTCDT only the unpowered EXAR serial to USB convertor
# leaks the output of the console back to the input in some
# cases. Therefore it is necessary to flush the UART before
# attempting to monitor keystrokes. The output of the
# console must be quiet, or in the case of the normal
# boot where the EXAR part is unpowered, the read of the
# keyboard may be reading output to the console screen.
# This problem never occurs if the EXAR part is connected
# to a PC, and is powered.
diff -Naru orig/common/autoboot.c new/common/autoboot.c
--- orig/common/autoboot.c 2019-08-15 10:56:58.183468370 -0500
+++ new/common/autoboot.c 2019-08-15 10:30:11.363515940 -0500
@@ -219,6 +219,12 @@
printf("Hit any key to stop autoboot: %2d ", bootdelay);
#endif
+ /* Flush input -- must be done because of loopback
+ * issue on MTCDT models with unpowered EXAR part
+ * which do loopback unintentionally by default.
+ */
+ while (tstc())
+ getc();
/*
* Check if key already pressed
*/
diff -Naru orig/configs/at91sam9x5ek_nandflash_defconfig new/configs/at91sam9x5ek_nandflash_defconfig
--- orig/configs/at91sam9x5ek_nandflash_defconfig 2019-08-15 10:49:30.223481632 -0500
+++ new/configs/at91sam9x5ek_nandflash_defconfig 2019-08-15 10:50:10.703480433 -0500
@@ -3,7 +3,7 @@
CONFIG_TARGET_AT91SAM9X5EK=y
CONFIG_SPL=n
CONFIG_SYS_EXTRA_OPTIONS="AT91SAM9X5,SYS_USE_NANDFLASH"
-CONFIG_BOOTDELAY=0
+CONFIG_BOOTDELAY=2
CONFIG_HUSH_PARSER=y
CONFIG_SYS_PROMPT="U-Boot> "
CONFIG_CMD_BOOTZ=y
|
