Added function to setup fpga attenuation and tx lut variable

8 files changed, 42 insertions, 11 deletions

diff --git a/libloragw/inc/loragw_fpga.h b/libloragw/inc/loragw_fpga.h
index 852f378..07418e4 100644
--- a/libloragw/inc/loragw_fpga.h
+++ b/libloragw/inc/loragw_fpga.h
@@ -99,7 +99,7 @@ float lgw_fpga_get_tx_notch_delay(void);
 @param tx_notch_freq TX notch filter frequency, in Hertz
 @return status of register operation (LGW_REG_SUCCESS/LGW_REG_ERROR)
 */
-int lgw_fpga_configure(uint32_t tx_notch_freq);
+int lgw_fpga_configure(uint32_t tx_notch_freq, bool fpga_attn_used);
 
 /**
 @brief LoRa concentrator FPGA register write
diff --git a/libloragw/inc/loragw_hal.h b/libloragw/inc/loragw_hal.h
index d5f9ade..632b72b 100644
--- a/libloragw/inc/loragw_hal.h
+++ b/libloragw/inc/loragw_hal.h
@@ -282,6 +282,7 @@ struct lgw_tx_gain_s {
     uint8_t pa_gain;    /*!> 2 bits, control of the external PA (SX1301 I/O) */
     uint8_t dac_gain;   /*!> 2 bits, control of the radio DAC */
     uint8_t mix_gain;   /*!> 4 bits, control of the radio mixer */
+    float  attenuation;   /*!> 7 bits, control of the attenuator , in dBm */
     int8_t  rf_power;   /*!> measured TX power at the board connector, in dBm */
 };
 
diff --git a/libloragw/inc/loragw_reg.h b/libloragw/inc/loragw_reg.h
index 1e98efa..085dfb6 100644
--- a/libloragw/inc/loragw_reg.h
+++ b/libloragw/inc/loragw_reg.h
@@ -413,7 +413,7 @@ concentrator, or if we also want to reset it and configure the FPGA (if present)
 used with SX1301AP2 reference design).
 @return status of register operation (LGW_REG_SUCCESS/LGW_REG_ERROR)
 */
-int lgw_connect(bool spi_only, uint32_t tx_notch_freq);
+int lgw_connect(bool spi_only, uint32_t tx_notch_freq, bool fpga_attn_used);
 
 /**
 @brief Disconnect LoRa concentrator by closing SPI link
diff --git a/libloragw/src/loragw_fpga.c b/libloragw/src/loragw_fpga.c
index 832152b..c2cb305 100644
--- a/libloragw/src/loragw_fpga.c
+++ b/libloragw/src/loragw_fpga.c
@@ -130,7 +130,7 @@ float lgw_fpga_get_tx_notch_delay(void) {
 
 /* ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ */
 
-int lgw_fpga_configure(uint32_t tx_notch_freq) {
+int lgw_fpga_configure(uint32_t tx_notch_freq, bool fpga_attn_used) {
     int x;
     int32_t val;
     bool spectral_scan_support, lbt_support;
@@ -175,6 +175,19 @@ int lgw_fpga_configure(uint32_t tx_notch_freq) {
             DEBUG_MSG("ERROR: Failed to configure FPGA polarity\n");
             return LGW_REG_ERROR;
         }
+        /* Set Attenuator mode to be used or not depending on if a full card with valid conf settings are given*/
+        if (fpga_version == 32) {
+            printf("INFO: Full Card with FPGA version %u detected\n", fpga_version);
+            if (fpga_attn_used == true) {
+                lgw_reg_w(LGW_FPGA_RF_ATTN_MODE, 0); 
+                printf("INFO: Valid config detected. Using Attenuator mode\n");
+            } else {
+                printf("INFO: Invalid config detected. Using Legacy mode\n");
+                lgw_reg_w(LGW_FPGA_RF_ATTN_MODE, 1);
+            }
+        } else {
+            lgw_reg_w(LGW_FPGA_RF_ATTN_MODE, 1);
+        }
     }
 
     /* Configure TX notch filter */
diff --git a/libloragw/src/loragw_hal.c b/libloragw/src/loragw_hal.c
index 8103751..3e6975b 100644
--- a/libloragw/src/loragw_hal.c
+++ b/libloragw/src/loragw_hal.c
@@ -136,13 +136,14 @@ static uint64_t fsk_sync_word= 0xC194C1; /* default FSK sync word (ALIGNED RIGHT
 static bool lorawan_public = false;
 static uint8_t rf_clkout = 0;
 
-static struct lgw_tx_gain_lut_s txgain_lut = {
+struct lgw_tx_gain_lut_s txgain_lut = {
     .size = 2,
     .lut[0] = {
         .dig_gain = 0,
         .pa_gain = 2,
         .dac_gain = 3,
         .mix_gain = 10,
+        .attenuation = -1.0,
         .rf_power = 14
     },
     .lut[1] = {
@@ -150,6 +151,7 @@ static struct lgw_tx_gain_lut_s txgain_lut = {
         .pa_gain = 3,
         .dac_gain = 3,
         .mix_gain = 14,
+        .attenuation = -1.0,
         .rf_power = 27
     }};
 
@@ -679,12 +681,16 @@ int lgw_txgain_setconf(struct lgw_tx_gain_lut_s *conf) {
             DEBUG_MSG("ERROR: TX gain LUT: External PA gain must not exceed 3\n");
             return LGW_HAL_ERROR;
         }
-
+        if (conf->lut[i].attenuation > 31.75) {
+            DEBUG_MSG("ERROR: TX gain LUT: External Attenuation gain must not exceed 31.75\n");
+            return LGW_HAL_ERROR;
+        }
         /* Set internal LUT */
         txgain_lut.lut[i].dig_gain = conf->lut[i].dig_gain;
         txgain_lut.lut[i].dac_gain = conf->lut[i].dac_gain;
         txgain_lut.lut[i].mix_gain = conf->lut[i].mix_gain;
         txgain_lut.lut[i].pa_gain  = conf->lut[i].pa_gain;
+        txgain_lut.lut[i].attenuation = conf->lut[i].attenuation;
         txgain_lut.lut[i].rf_power = conf->lut[i].rf_power;
     }
 
@@ -710,8 +716,8 @@ int lgw_start(void) {
     if (lgw_is_started == true) {
         DEBUG_MSG("Note: LoRa concentrator already started, restarting it now\n");
     }
-
-    reg_stat = lgw_connect(false, rf_tx_notch_freq[rf_tx_enable[1]?1:0]);
+    printf("Attenuation value %f\n", txgain_lut.lut[0].attenuation);
+    reg_stat = lgw_connect(false, rf_tx_notch_freq[rf_tx_enable[1]?1:0], txgain_lut.lut[0].attenuation > -1.0?true:false);
     if (reg_stat == LGW_REG_ERROR) {
         DEBUG_MSG("ERROR: FAIL TO CONNECT BOARD\n");
         return LGW_HAL_ERROR;
@@ -1433,6 +1439,17 @@ int lgw_send(struct lgw_pkt_tx_s pkt_data) {
     /* Set digital gain from LUT */
     lgw_reg_w(LGW_TX_GAIN, txgain_lut.lut[pow_index].dig_gain);
 
+    int32_t read_value;
+    lgw_reg_r(LGW_FPGA_RF_ATTN_MODE, &read_value);
+    if (read_value == 0) {
+        lgw_reg_w(LGW_FPGA_RF_ATTN_VALUE, txgain_lut.lut[pow_index].attenuation * 4);
+        printf("dig_gain for sent packet %d\n", txgain_lut.lut[pow_index].dig_gain);
+        printf("mix_gain for sent packet %d\n", txgain_lut.lut[pow_index].mix_gain);
+        printf("pa_gain for sent packet %d\n", txgain_lut.lut[pow_index].pa_gain);
+        printf("Power for sent packet %d\n", txgain_lut.lut[pow_index].rf_power);
+        printf("Attenuation for sent packet %f\n", txgain_lut.lut[pow_index].attenuation);
+    }
+
     /* fixed metadata, useful payload and misc metadata compositing */
     transfer_size = TX_METADATA_NB + pkt_data.size; /*  */
     payload_offset = TX_METADATA_NB; /* start the payload just after the metadata */
diff --git a/libloragw/src/loragw_reg.c b/libloragw/src/loragw_reg.c
index 4d689da..e040942 100644
--- a/libloragw/src/loragw_reg.c
+++ b/libloragw/src/loragw_reg.c
@@ -511,7 +511,7 @@ bool check_fpga_version(uint8_t version) {
 }
 
 /* Concentrator connect */
-int lgw_connect(bool spi_only, uint32_t tx_notch_freq) {
+int lgw_connect(bool spi_only, uint32_t tx_notch_freq, bool fpga_attn_used) {
     int spi_stat = LGW_SPI_SUCCESS;
     uint8_t u = 0;
     int x;
@@ -548,7 +548,7 @@ int lgw_connect(bool spi_only, uint32_t tx_notch_freq) {
             lgw_spi_w(lgw_spi_target, lgw_spi_mux_mode, LGW_SPI_MUX_TARGET_FPGA, 0, 1);
             lgw_spi_w(lgw_spi_target, lgw_spi_mux_mode, LGW_SPI_MUX_TARGET_FPGA, 0, 0);
             /* FPGA configure */
-            x = lgw_fpga_configure(tx_notch_freq);
+            x = lgw_fpga_configure(tx_notch_freq, fpga_attn_used);
             if (x != LGW_REG_SUCCESS) {
                 DEBUG_MSG("ERROR CONFIGURING FPGA\n");
                 return LGW_REG_ERROR;
diff --git a/libloragw/tst/test_loragw_cal.c b/libloragw/tst/test_loragw_cal.c
index 533d189..067c157 100644
--- a/libloragw/tst/test_loragw_cal.c
+++ b/libloragw/tst/test_loragw_cal.c
@@ -263,7 +263,7 @@ int main(int argc, char **argv)
     printf("Number of calibration iterations: %d\n",nb_cal);
     printf("Calibration command: brd: %d, chip: %d, dac: %d\n\n", cal_cmd >> 6, 1257-2*((cal_cmd & 0x20) >> 5), 2+((cal_cmd & 0x10) >> 4));
 
-    x = lgw_connect(false, DEFAULT_TX_NOTCH_FREQ);
+    x = lgw_connect(false, DEFAULT_TX_NOTCH_FREQ, false);
     if (x == -1) {
         printf("ERROR: FAIL TO CONNECT BOARD\n");
         return -1;
diff --git a/libloragw/tst/test_loragw_reg.c b/libloragw/tst/test_loragw_reg.c
index 37a6f5a..2804d5e 100644
--- a/libloragw/tst/test_loragw_reg.c
+++ b/libloragw/tst/test_loragw_reg.c
@@ -37,7 +37,7 @@ int main()
 
     printf("Beginning of test for loragw_reg.c\n");
 
-    lgw_connect(false, 129E3);
+    lgw_connect(false, 129E3, false);
     /* 2 SPI transactions:
     -> 0x80 0x00        <- 0x00 0x00        forcing page 0
     -> 0x01 0x00        <- 0x00 0x64        checking version