blob: 748aafb4e1d1db4adf39949626cc0cbca5568ee2 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
|
# That file will be included in the Makefile files that have hardware dependencies
### SPI interface to the concentrator ###
# Accepted values:
# native Linux native SPI driver (/dev/spidev32766.0)
# ftdi FTDI SPI-over-USB bridge using libmpsse/libftdi/libusb
CFG_SPI= ftdi
### Concentrator chip ###
# Accepted values:
# sx1301 Semtech SX1301 production chip
# fpga1301 FPGA containing the SX1301 IP
CFG_CHIP= sx1301
### Radio chip(s) ###
# Accepted values:
# sx1257 Dual SX1257 transceivers, covering 860-1000 MHz
# sx1255 Dual SX1255 transceivers, covering 400-510 MHz
CFG_RADIO= sx1257
### RF band configuration ###
# Used to configured frequency restrictions (eg. if a SAW filter is installed)
# Accepted values:
# full Full range supported by the radio(s)
# eu868 ETSI 868 (866) MHz band
# us915 FCC 915 MHz band
# cn470 China 470 MHz band
# eu433 ETSI 433 MHz band
# cn780 China 780 MHz band
CFG_BAND= eu868
### Board misc parameters & calibration ###
# Used to configure misc board options.
# RX RSSI indication and TX power are highly dependant on radio, band, filter
# and RF front-ends, and must be calibrated for each new board design.
# Available calibration parameters:
# dev_nano_868 FPGA-based nano-concentrator, with 868 MHz SAW filter
# ref_1301_868 SX1301 reference board with SX1257 radios, 868 MHz filters
# ref_1301_433 SX1301 reference board with SX1255 radios, 433 MHz filters
# kerlink_868 Kerlink LoRa 868MHz gateway
# kerlink_868_27dbm Kerlink LoRa 868MHz gateway with 27dBm capability
# kerlink_433 Kerlink LoRa 433MHz gateway
# cisco_433 Cisco LoRa 433MHz gateway
# cisco_470 Cisco LoRa 470MHz gateway
# cisco_780 Cisco LoRa 780MHz gateway
# Keep empty for no calibration parameters (neutral values will be used).
CFG_BRD= ref_1301_868
### Network Type ###
# Accepted values:
# private Default
# lora_mac Only compliant with devices running LoRa MAC
CFG_NET= private
### Debug options ###
# Set the DEBUG_* to 1 to activate debug mode in individual modules.
# Warning: that makes the module *very verbose*, do not use for production
DEBUG_AUX= 0
DEBUG_SPI= 0
DEBUG_REG= 0
DEBUG_HAL= 0
DEBUG_GPS= 0
|
