diff -uprN -X linux-2.6.28/Documentation/dontdiff linux-2.6.28-vanilla/arch/arm/mach-at91/at91sam9260_devices.c linux-2.6.28/arch/arm/mach-at91/at91sam9260_devices.c --- linux-2.6.28-vanilla/arch/arm/mach-at91/at91sam9260_devices.c 2008-12-24 17:26:37.000000000 -0600 +++ linux-2.6.28/arch/arm/mach-at91/at91sam9260_devices.c 2010-04-05 15:25:29.000000000 -0500 @@ -183,9 +183,9 @@ void __init at91_add_device_eth(struct a at91_set_B_periph(AT91_PIN_PA25, 0); /* ERX2 */ at91_set_B_periph(AT91_PIN_PA26, 0); /* ERX3 */ at91_set_B_periph(AT91_PIN_PA27, 0); /* ERXCK */ - at91_set_B_periph(AT91_PIN_PA23, 0); /* ETX2 */ - at91_set_B_periph(AT91_PIN_PA24, 0); /* ETX3 */ - at91_set_B_periph(AT91_PIN_PA22, 0); /* ETXER */ + at91_set_B_periph(AT91_PIN_PA10, 0); /* ETX2 -- DJS was PA23 */ + at91_set_B_periph(AT91_PIN_PA11, 0); /* ETX3 -- DJS was PA24 */ + /*at91_set_B_periph(AT91_PIN_PA22, 0);*/ /* ETXER -- DJS commented this out */ } eth_data = *data; diff -uprN -X linux-2.6.28/Documentation/dontdiff linux-2.6.28-vanilla/arch/arm/mach-at91/board-sam9g20ek.c linux-2.6.28/arch/arm/mach-at91/board-sam9g20ek.c --- linux-2.6.28-vanilla/arch/arm/mach-at91/board-sam9g20ek.c 2008-12-24 17:26:37.000000000 -0600 +++ linux-2.6.28/arch/arm/mach-at91/board-sam9g20ek.c 2010-05-03 14:46:54.000000000 -0500 @@ -57,6 +57,9 @@ static void __init ek_map_io(void) /* USART1 on ttyS2. (Rx, Tx, RTS, CTS) */ at91_register_uart(AT91SAM9260_ID_US1, 2, ATMEL_UART_CTS | ATMEL_UART_RTS); + /* USART2 on ttyS3. (Rx,Tx) 20090608 TAB added for GPS */ + at91_register_uart(AT91SAM9260_ID_US2, 3, 0); + /* set serial console to ttyS0 (ie, DBGU) */ at91_set_serial_console(0); } @@ -78,8 +81,8 @@ static struct at91_usbh_data __initdata * USB Device port */ static struct at91_udc_data __initdata ek_udc_data = { - .vbus_pin = AT91_PIN_PC5, - .pullup_pin = 0, /* pull-up driven by UDC */ + .vbus_pin = AT91_PIN_PC12, /* DJS -- was AT91_PIN_PC5, */ + .pullup_pin = 0, /* pull-up driven by UDC */ }; @@ -103,6 +106,16 @@ static struct spi_board_info ek_spi_devi }, #endif #endif + { + .modalias = "mts-io-sregout", + .chip_select = 0, + .bus_num = 1, + }, + { + .modalias = "mts-io-board-temp", + .chip_select = 2, + .bus_num = 1, + }, }; @@ -111,7 +124,7 @@ static struct spi_board_info ek_spi_devi */ static struct at91_eth_data __initdata ek_macb_data = { .phy_irq_pin = AT91_PIN_PA7, - .is_rmii = 1, + .is_rmii = 0, /* DJS -- changed from 1 to 0 since using MII */ }; @@ -120,22 +133,53 @@ static struct at91_eth_data __initdata e */ static struct mtd_partition __initdata ek_nand_partition[] = { { - .name = "Bootstrap", - .offset = 0, - .size = 4 * SZ_1M, + .name = "MTNCG-NANDFlash", + .offset = 0, + .size = 256*1024*1024, }, { - .name = "Partition 1", - .offset = MTDPART_OFS_NXTBLK, - .size = 60 * SZ_1M, + .name = "AT91Bootstrap", + .offset = 0, + .size = 128*1024, }, { - .name = "Partition 2", - .offset = MTDPART_OFS_NXTBLK, + .name = "UBoot", + .offset = 128*1024, + .size = 256*1024, + }, + { + .name = "UBoot Config", + .offset = 384*1024, + .size = 128*1024, + }, + { + .name = "UBoot Redundant Config", + .offset = 512*1024, + .size = 128*1024, + }, + { + .name = "uImage", + .offset = 640*1024, + .size = 59*128*1024, + }, + { + .name = "Config", + .offset = 64*128*1024, + .size = 64*128*1024, + }, + { + .name = "Oem Config", + .offset = 128*128*1024, + .size = 64*128*1024, + }, + { + .name = "Rootfs", + .offset = 192*128*1024, .size = MTDPART_SIZ_FULL, }, }; + static struct mtd_partition * __init nand_partitions(int size, int *num_partitions) { *num_partitions = ARRAY_SIZE(ek_nand_partition); @@ -159,11 +203,13 @@ static struct atmel_nand_data __initdata /* * MCI (SD/MMC) - * det_pin, wp_pin and vcc_pin are not connected + * vcc_pin is not connected */ static struct at91_mmc_data __initdata ek_mmc_data = { .slot_b = 1, .wire4 = 1, + .det_pin = AT91_PIN_PA6, /* DJS -- was ... not connected */ + .wp_pin = AT91_PIN_PA9, /* DJS -- was ... not connected */ }; @@ -171,17 +217,12 @@ static struct at91_mmc_data __initdata e * LEDs */ static struct gpio_led ek_leds[] = { - { /* "bottom" led, green, userled1 to be defined */ - .name = "ds5", - .gpio = AT91_PIN_PA6, + { /* "status" led, green */ + .name = "status", + .gpio = AT91_PIN_PA30, /* DJS -- was AT91_PIN_PA9, */ .active_low = 1, - .default_trigger = "none", - }, - { /* "power" led, yellow */ - .name = "ds1", - .gpio = AT91_PIN_PA9, .default_trigger = "heartbeat", - } + }, }; static void __init ek_board_init(void)