diff -Naru linux-3.12.27.orig/arch/arm/boot/dts/mtcap.dts linux-3.12.27/arch/arm/boot/dts/mtcap.dts
--- linux-3.12.27.orig/arch/arm/boot/dts/mtcap.dts	1969-12-31 18:00:00.000000000 -0600
+++ linux-3.12.27/arch/arm/boot/dts/mtcap.dts	2017-02-24 14:31:20.750798116 -0600
@@ -0,0 +1,230 @@
+/*
+ * DTS file for Multi-Tech Systems MTCAP Hardware
+ */
+
+/dts-v1/;
+#include "at91sam9g25.dtsi"
+
+/ {
+	model = "Multi-Tech Systems MTCAP";
+	compatible = "atmel,at91sam9g25ek", "atmel,at91sam9x5ek", "atmel,at91sam9x5", "atmel,at91sam9";
+
+	chosen {
+		bootargs = "mem=256M console=ttyS0,115200 root=/dev/mtdblock8 ro rootfstype=jffs2";
+	};
+
+	aliases {
+	    spi0 = &spi0;
+	};
+
+	memory {
+		reg = <0x20000000 0x8000000>;
+	};
+
+	clocks {
+		#address-cells = <1>;
+		#size-cells = <1>;
+		ranges;
+
+		main_clock: clock@0 {
+			compatible = "atmel,osc", "fixed-clock";
+			clock-frequency = <12000000>;
+		};
+	};
+
+	ahb {
+		apb {
+			macb0: ethernet@f802c000 {
+				phy-mode = "rmii";
+				status = "okay";
+			};
+
+			mmc0: mmc@f0008000 {
+				pinctrl-names = "default";
+				pinctrl-0 = <
+					/* &pinctrl_board_mmc0 */
+					&pinctrl_mmc0_slot0_clk_cmd_dat0
+					&pinctrl_mmc0_slot0_dat1_3>;
+				status = "okay";
+				slot@0 {
+					reg = <0>;
+					bus-width = <4>;
+				};
+			};
+
+			pinctrl@fffff400 {
+				mmc0 {
+					pinctrl_board_mmc0: mmc0-board {
+						atmel,pins =
+							<AT91_PIOA 4 AT91_PERIPH_GPIO AT91_PINCTRL_PULL_UP_DEGLITCH>;  /* PA4 gpio pin pull up and deglitch - WIFI enable */
+					};
+				};
+
+				nand {
+					pinctrl_nand: nand-0 {
+						atmel,pins =
+							<AT91_PIOD 0 AT91_PERIPH_A AT91_PINCTRL_PULL_UP	/* PD0 periph A Read Enable */
+							AT91_PIOD 1 AT91_PERIPH_A AT91_PINCTRL_PULL_UP	/* PD1 periph A Write Enable */
+							AT91_PIOD 2 AT91_PERIPH_A AT91_PINCTRL_PULL_UP	/* PD2 periph A Address Latch Enable */
+							AT91_PIOD 3 AT91_PERIPH_A AT91_PINCTRL_PULL_UP	/* PD3 periph A Command Latch Enable */
+							AT91_PIOD 4 AT91_PERIPH_GPIO AT91_PINCTRL_PULL_UP	/* PD4 gpio Chip Enable pin pull_up */
+							AT91_PIOC 31 AT91_PERIPH_GPIO AT91_PINCTRL_PULL_UP	/* PC31 gpio RDY/BUSY pin pull_up */
+							AT91_PIOD 6 AT91_PERIPH_A AT91_PINCTRL_PULL_UP	/* PD6 periph A Data bit 0 */
+							AT91_PIOD 7 AT91_PERIPH_A AT91_PINCTRL_PULL_UP	/* PD7 periph A Data bit 1 */
+							AT91_PIOD 8 AT91_PERIPH_A AT91_PINCTRL_PULL_UP	/* PD8 periph A Data bit 2 */
+							AT91_PIOD 9 AT91_PERIPH_A AT91_PINCTRL_PULL_UP	/* PD9 periph A Data bit 3 */
+							AT91_PIOD 10 AT91_PERIPH_A AT91_PINCTRL_PULL_UP	/* PD10 periph A Data bit 4 */
+							AT91_PIOD 11 AT91_PERIPH_A AT91_PINCTRL_PULL_UP	/* PD11 periph A Data bit 5 */
+							AT91_PIOD 12 AT91_PERIPH_A AT91_PINCTRL_PULL_UP	/* PD12 periph A Data bit 6 */
+							AT91_PIOD 13 AT91_PERIPH_A AT91_PINCTRL_PULL_UP>;	/* PD13 periph A Data bit 7 */
+					};
+
+					pinctrl_nand_16bits: nand_16bits-0 {
+						atmel,pins =
+							<AT91_PIOD 14 AT91_PERIPH_A AT91_PINCTRL_PULL_UP	/* PD14 periph A Data bit 8 */
+							AT91_PIOD 15 AT91_PERIPH_A AT91_PINCTRL_PULL_UP	/* PD15 periph A Data bit 9 */
+							AT91_PIOD 16 AT91_PERIPH_A AT91_PINCTRL_PULL_UP	/* PD16 periph A Data bit 10 */
+							AT91_PIOD 17 AT91_PERIPH_A AT91_PINCTRL_PULL_UP	/* PD17 periph A Data bit 11 */
+							AT91_PIOD 18 AT91_PERIPH_A AT91_PINCTRL_PULL_UP	/* PD18 periph A Data bit 12 */
+							AT91_PIOD 19 AT91_PERIPH_A AT91_PINCTRL_PULL_UP	/* PD19 periph A Data bit 13 */
+							AT91_PIOD 20 AT91_PERIPH_A AT91_PINCTRL_PULL_UP	/* PD20 periph A Data bit 14 */
+							AT91_PIOD 21 AT91_PERIPH_A AT91_PINCTRL_PULL_UP>;	/* PD21 periph A Data bit 15 */
+					};
+				};
+			};
+
+			rtc@fffffeb0 {
+				status = "okay";
+			};
+
+			i2c0: i2c@f8010000 {
+				compatible = "i2c-gpio";
+				status = "okay";
+
+				id_eeprom@56 {
+					compatible = "atmel,24c04";
+					reg = <0x56>;
+					pagesize = <16>;
+				};
+			};
+
+			spi0: spi@f0000000 {
+				status = "okay";
+				cs-gpios = <&pioA 7 0>, <0>, <0>, <0>;
+				lora-spi@0 {
+					compatible = "spidev";
+					spi-max-frequency = <2000000>;
+					reg = <0>;
+				};
+			};
+
+			dbgu: serial@fffff200 {
+				status = "okay";
+			};
+
+			uart0: serial@f8040000 {
+				status = "okay";
+			};
+
+			watchdog@fffffe40 {
+				status = "okay";
+			};
+		};
+
+		nand0: nand@40000000 {
+			nand-bus-width = <8>;
+			nand-ecc-mode = "hw";
+			atmel,has-pmecc;	/* Enable PMECC */
+			atmel,pmecc-sector-size = <512>;
+			status = "okay";
+			reg = < 0x40000000 0x10000000
+				0xffffe000 0x600    /* PMECC Registers */
+				0xffffe600 0x200    /* PMECC Error Location Registers */
+				0x00100000 0x100000 /* PMECC looup table in ROM code  */
+			      >;
+			atmel,pmecc-lookup-table-offset = <0x8000 0x10000>;
+			gpios = < &pioC 31 GPIO_ACTIVE_HIGH
+				  &pioD 4 GPIO_ACTIVE_HIGH
+				  0
+				>;
+			atmel,pmecc-cap = <4>;
+			atmel,nand-has-dma;
+
+			nand@0 {
+				label = "NANDFlash";
+				reg = <0x0 0x10000000>;
+			};
+			at91bootstrap@0 {
+				label = "at91bootstrap";
+				reg = <0x0 0x40000>;
+			};
+			uboot@40000 {
+				label = "u-Boot";
+				reg = <0x40000 0x80000>;
+			};
+			ubootconfig0@c0000 {
+				label = "u-Boot Config";
+				reg = <0xc0000 0xa0000>;
+			};
+			ubootconfig1@160000 {
+				label = "u-Boot Redundant Config";
+				reg = <0x160000 0xa0000>;
+			};
+			uImage@200000 {
+				label = "uImage";
+				reg = <0x200000 0x600000>;
+			};
+			config0@800000 {
+				label = "Config";
+				reg = <0x800000 0x800000>;
+			};
+			config1@1000000 {
+				label = "OEM Config";
+				reg = <0x1000000 0x800000>;
+			};
+			rootfs@1800000 {
+				label = "Rootfs";
+				reg = <0x1800000 0xe800000>;
+			};
+		};
+
+		usb0: ohci@00600000 {
+			status = "okay";
+			num-ports = <3>;
+		};
+
+		usb1: ehci@00700000 {
+			status = "okay";
+		};
+	};
+
+	leds {
+		compatible = "gpio-leds";
+		pc25 {
+			label = "led-status";
+			gpios = <&pioC 25 GPIO_ACTIVE_HIGH>;
+			linux,default-trigger = "default-on";
+		};
+		pc15 {
+			label = "led-lora";
+			gpios = <&pioC 15 GPIO_ACTIVE_LOW>;
+		};
+		pc16 {
+			label = "led-cd";
+			gpios = <&pioC 16 GPIO_ACTIVE_LOW>;
+		};
+		pc20 {
+			label = "led-wifi";
+			gpios = <&pioC 20 GPIO_ACTIVE_LOW>;
+		};
+	};
+
+	i2c@0 {
+		status = "okay";
+		id_eeprom@56 {
+			compatible = "atmel,24c04";
+			reg = <0x56>;
+			pagesize = <16>;
+		};
+	};
+};
diff -Naru linux-3.12.27.orig/arch/arm/boot/dts/Makefile linux-3.12.27/arch/arm/boot/dts/Makefile
--- linux-3.12.27.orig/arch/arm/boot/dts/Makefile	2017-02-24 14:25:30.983064241 -0600
+++ linux-3.12.27/arch/arm/boot/dts/Makefile	2017-02-24 14:26:50.424821432 -0600
@@ -35,6 +35,7 @@
 dtb-$(CONFIG_ARCH_AT91) += at91sam9g35ek.dtb
 dtb-$(CONFIG_ARCH_AT91) += at91sam9x25ek.dtb
 dtb-$(CONFIG_ARCH_AT91) += at91sam9x35ek.dtb
+dtb-$(CONFIG_ARCH_AT91) += mtcap.dtb
 # sama5d3
 dtb-$(CONFIG_ARCH_AT91)	+= sama5d31ek.dtb
 dtb-$(CONFIG_ARCH_AT91)	+= sama5d33ek.dtb