#
# Skip loading the RS9113 related drivers if
# set to zero.
#
RS9113_LOAD=1

# Parameters for rs9113 driver
#
# Enable Antenna Diversity (1)
RSI_ANTENNA_DIVERSITY=0

# COEX_MODE options:
#		1    WLAN STATION or WLAN ACCESS POINT
#               3    WLAN ACCESS POINT + STATION MODE(on multiple vaps)
#		4    BT EDR MODE
#		5    WLAN STATION + BT EDR MODE
#		6    WLAN ACCESS POINT + BT EDR MODE
#		8    BT LE MODE
#		9    WLAN STATION + BT LE MODE
#		10   WLAN ACCESS POINT + BT LE MODE
#		12   BT EDR + BT LE MODE 							
#		13   WLAN STATION + BT EDR MODE + BT LE MODE
#		14   WLAN ACCESS POINT + BT EDR MODE+ BT LE MODE
COEX_MODE=1


#	2 – Select internal antenna
#	3 – Select external antenna
ANT_SEL_VAL=2

RSI_ANTENNA_DIVERSITY=0

# Parameters are described here:
# https://github.com/SiliconLabs/RS911X-nLink-OSD/blob/master/rsi/rsi_91x_main.c
#
# RX_DATA_INACTIVE_INTERVAL
# SLEEP_IND_GPIO_SEL"                      
# ULP_GPIO_READ
# ULP_GPIO_WRITE"                
# PS_SLEEP_TYPE
# MAX_SP_LEN
# ENABLED_UAPSD
# LP_HANDSHAKE_MODE
# ULP_HANDSHAKE_MODE
# PEER_DIST
# BT_FEATURE_BITMAP
# UART_DEBUG
# EXT_OPT
# BLE_ROLES
# BT_BDR_MODE
# THREE_WIRE_COEX
# ANCHOR_POINT_GAP
# HOST_INTF_ON_DEMAND
# SLEEP_CLK_SOURCE_SEL
# FEATURE_BITMAP_9116
# ENABLE_40MHZ_IN_2G
# XTAL_GOOD_TIME
# RSI_ZONE_ENABLED


# Time to hold high, then hold low on reset during driver load reset
SLEEPTIME=100000

# Time to wait while looping for interrupt and wake-up pins
# to go high.
INTSLEEPTIME=100000

# 00 is world.  IEEE Country Codes
# for cfg80211 driver.
COUNTRY_CODE=00