diff options
Diffstat (limited to 'recipes-connectivity/lora/lora-gateway/library.cfg')
| -rw-r--r-- | recipes-connectivity/lora/lora-gateway/library.cfg | 73 |
1 files changed, 73 insertions, 0 deletions
diff --git a/recipes-connectivity/lora/lora-gateway/library.cfg b/recipes-connectivity/lora/lora-gateway/library.cfg new file mode 100644 index 0000000..01b066d --- /dev/null +++ b/recipes-connectivity/lora/lora-gateway/library.cfg @@ -0,0 +1,73 @@ +# That file will be included in the Makefile files that have hardware dependencies + +### SPI interface to the concentrator ### +# Accepted values: +# native Linux native SPI driver (/dev/spidev32766.0) +# ftdi FTDI SPI-over-USB bridge using libmpsse/libftdi/libusb + +CFG_SPI= ftdi +CFG_SPI_DEV = "/dev/spidev32766.2" + +### Concentrator chip ### +# Accepted values: +# sx1301 Semtech SX1301 production chip +# fpga1301 FPGA containing the SX1301 IP + +CFG_CHIP= sx1301 + +### Radio chip(s) ### +# Accepted values: +# sx1257 Dual SX1257 transceivers, covering 860-1000 MHz +# sx1255 Dual SX1255 transceivers, covering 400-510 MHz + +CFG_RADIO= sx1257 + +### RF band configuration ### +# Used to configured frequency restrictions (eg. if a SAW filter is installed) +# Accepted values: +# full Full range supported by the radio(s) +# eu868 ETSI 868 (866) MHz band +# us915 FCC 915 MHz band +# cn470 China 470 MHz band +# eu433 ETSI 433 MHz band +# cn780 China 780 MHz band + +CFG_BAND= full + +### Board misc parameters & calibration ### +# Used to configure misc board options. +# RX RSSI indication and TX power are highly dependant on radio, band, filter +# and RF front-ends, and must be calibrated for each new board design. +# Available calibration parameters: +# dev_nano_868 FPGA-based nano-concentrator, with 868 MHz SAW filter +# ref_1301_868 SX1301 reference board with SX1257 radios, 868 MHz filters +# ref_1301_433 SX1301 reference board with SX1255 radios, 433 MHz filters +# kerlink_868 Kerlink LoRa 868MHz gateway +# kerlink_433 Kerlink LoRa 433MHz gateway +# cisco_433 Cisco LoRa 433MHz gateway +# cisco_470 Cisco LoRa 470MHz gateway +# cisco_780 Cisco LoRa 780MHz gateway +# Keep empty for no calibration parameters (neutral values will be used). + +# MTAC-LORA 900MHz +CFG_BRD= mtaclora + +### Network Type ### +# Accepted values: +# private Default +# lora_mac Only compliant with devices running LoRa MAC + +CFG_NET= private + +### Debug options ### +# Set the DEBUG_* to 1 to activate debug mode in individual modules. +# Warning: that makes the module *very verbose*, do not use for production + +DEBUG_AUX= 0 +DEBUG_SPI= 0 +DEBUG_REG= 0 +# jjg - turning this on is useful to get HAL-related error messages that +# don't print out otherwise. It doesn't seem to add that much printing +# under normal operation. +DEBUG_HAL= 1 +DEBUG_GPS= 0 |