diff options
Diffstat (limited to 'loragw_tx_test/README.TXT')
| -rw-r--r-- | loragw_tx_test/README.TXT | 65 |
1 files changed, 65 insertions, 0 deletions
diff --git a/loragw_tx_test/README.TXT b/loragw_tx_test/README.TXT new file mode 100644 index 0000000..2f95735 --- /dev/null +++ b/loragw_tx_test/README.TXT @@ -0,0 +1,65 @@ + / _____) _ | | + ( (____ _____ ____ _| |_ _____ ____| |__ + \____ \| ___ | (_ _) ___ |/ ___) _ \ + _____) ) ____| | | || |_| ____( (___| | | | + (______/|_____)_|_|_| \__)_____)\____)_| |_| + ©2013 Semtech-Cycleo + +Lora Gateway packet sender +=========================== + +1. Introduction +---------------- + +This software is used to send test packets with a Lora concentrator. The packets +contain little information, on no protocol (ie. MAC address) information but +can be used to assess the functionality of a gateway downlink using other +gateways as receivers. + +2. Dependencies +---------------- + +This program is a typical example of Lora Gateway HAL usage for sending packets. + +Only high-level functions are used (the ones contained in loragw_hal) so there +is no hardware dependencies assuming the HAL is matched with the proper version +of the hardware. +Data structures of the sent packets are accessed by name (ie. not at a +binary level) so new functionalities can be added to the API without affecting +that program at all. + +It was tested with beta8 of the libloragw library, and should be compatible +with any later version of the library assuming the API is downward-compatible. + +3. Usage +--------- + +The application runs until the specified number of packets have been send. +Press Ctrl+C to stop the application before that. + +Use the -f option followed by a real number (decimal point and scientific +'E notation' are OK) to specify the modulation central frequency. +Use the -s option to specify the Spreading Factor of Lora modulation (values 7 +to 12 are valid). +Use the -b option to set Lora modulation bandwidth in kHz (accepted values: 125, +250 or 500). +Use the -p option to set the concentrator TX power in dBm. Not all values are +supported by hardware (typically 14 et 20 dBm are supported, other values might +not give expected power). Check with a RF power meter before connecting any +sensitive equipment. +Use the -t option to specify the number of milliseconds of pause between +packets. Using zero will result in a quasi-continuous emission. +Use the -x to specify how many packets should be sent. + +The packets are 20 bytes long, and protected by the smallest supported ECC. + +The payload content is: +[T][E][S][T][packet counter MSB][packet counter MSB] followed by ASCII padding. +All Lora data is whitened, so the padding has no influence whatsoever on the +packet error rate. + +4. Changelog +------------- + +2013-10-18, beta 1 +Initial version. |